Need to Remove a Toto Washlet? Here's a Step-by-Step Guide

If you're looking to Toto Washlet Removal in San Diego from bathroom, then this guide is for you!

Removing a Toto washlet can be a tricky process, but with the right steps, you can take it out safely and quickly. This guide will provide you with a step-by-step approach to successful Toto toilet seat removal.

Follow these instructions, and you'll be done in no time.

• Disconnect the water valve
  
  
• Sponge any leftover water into the toilet bowl after flushing.
  
  
• Just in case, place a bucket beneath the water connection on the tank.
  
  
• Unscrew the base of the toilet: By hand or using adjustable joint pliers, unscrew the toilet's water connection.
  
  
• Use pliers to unscrew the nuts, then take out all of the washers that are securing them
  
  
• Lift the toilet bowl and seat: Straight up raise and remove the toilet. You might want to enlist a helper if you're removing a Toto because they can be heavy and it's crucial to keep them from tipping so water doesn't spill.
  
  
• Remove the wax ring: Using a putty knife, remove the old wax off the toilet flange, wrap it up in paper towels, and throw it away.
  
  
• Clean the area and install a new wax ring
  
  
• Place the toilet bowl and seat back on the base
  
  
• Plug the toilet waste inlet to stop the pipes' sewer gas leaks
  
  
• Last but not least, reconnect the water supply

If there are no toilet bolts, what should you do?If you’ve ever been in the middle of a Toto washlet removal and realized there are no toilet bolts, don’t panic. This is fairly common, and it’s easy to solve.

Instead of using bolts, many toilets are held in place with a metal ring called a retaining clip. To remove this clip, start by unscrewing the two screws that hold the clip in place. Then, use a flathead screwdriver or similar tool to gently pry the clip off the floor.

Once you’ve done this, you’ll be able to lift your toilet bowl and seat off of the base. Keep in mind that you may need to wiggle the bowl slightly to get it out from under the retaining clip. This should help you complete your Toto washlet removal without any problems.

When the Toilet's Mounting Bolts Are at the BackIf your Toto washlet has its mounting bolts in the back of the toilet, you will need to take a few extra steps to remove it. The first thing to do is to turn off the water supply to the toilet. Next, use a ratchet or wrench to unscrew the bolts, and then carefully lift the toilet bowl and seat it off the base.

Once you have removed the toilet bowl and seat, you may need to use a flat-head screwdriver to help remove the wax ring from around the rim of the bowl. Be sure to wear protective gloves, as the wax ring may be difficult to remove. Once the wax ring is off, you can move on to the next step.

Now that the wax ring is removed, it’s time to place the toilet bowl and seat it back on the base. Line up the two pieces and make sure they fit snugly together. You may need to reattach the mounting bolts if you had to remove them earlier.

Once the toilet bowl and seat are securely attached, you can clean up any excess wax or debris around the area. Then, install a new wax ring around the rim of the bowl. Finally, turn the water supply back on and flush the toilet a few times to make sure it’s working properly. And you're done!

Contact EZ Plumbing USA for any kind of Toto washlet services.